After the last step, your NSS server will be updated with your feed settings, and it will be ready to receive data from Zscaler Nanolog and send it to your Devo Relay. We encourage you to experiment with the following commands to verify that your feeds are updated and that your NSS server is connected with Devo Relay.

To view troubleshooting help command information:
```
sudo nss troubleshoot help
```
To show the active connections on the service IP address:
```
sudo nss troubleshoot netstat
```
The output is similar to that of the Netstat utility.
To show the connections and their status:
```
sudo nss troubleshoot connection
```
This command will test the connection status over a period of time and indicate whether the connections are stable or flapping.
To show the status of the NSS feeds:
```
sudo nss troubleshoot feeds
```
This command will test the status of the feeds and determine if the logs are queued due to the slow consumption of logs by the Devo Relay.

Browser not supported